Fiamma Table tripod

by Bill Mon Jun 26, 2023 3:49 pm

I have a 2017 Symbol. Does anybody know if the tubular chrome coffee table stand that Auto Sleeper supply fits the Fiamma table tripod so that the table can be taken outside. The Fiamma's own chrome column has plastic fittings on the ends. Thanks. Bill

by Paulmold Mon Jun 26, 2023 3:57 pm

As far as I know , yes, the taper of the tube should be the same.
I used to use a chrome pole in a Fiamma tripod (old model with metal legs / feet

by Kdc Mon Jun 26, 2023 4:03 pm

I use my small table inside and out and have one of each type of leg.One metal tubular and one with plastic ends. The reason for my two tube is to achieve different heights between in and out side.

by Bill Mon Jun 26, 2023 4:26 pm

Kdc wrote:I use my small table inside and out and have one of each type of leg.One metal tubular and one with plastic ends. The reason for my two tube is to achieve different heights between in and out side.

Thank you for that idea. I assume that the Fiamma column with the plastic fittings will fit into the Auto Sleeper coffee table top without any modifications ? Bill

by Kdc Mon Jun 26, 2023 6:15 pm

My column with plastic ends fit into base on supplied small table and consequently the floor plate fitted in van.
Incidentally I can and do use the tripod in the van to have the table in different position to the as fitted floor base which in the Warwick is too far to the rear in my opinion. This leg has to be shorter due to height of tripod hence my having two legs.

by FreelanderUK Mon Jun 26, 2023 7:01 pm

The metal tube will fit the tripod but as mentioned makes the table to high for outside use , we bought the aluminium one with black ends and I cut to a hight that is good for use out side and can be used inside in the socket also with table top

[You must be registered and logged in to see this link.]

by brianf Mon Jul 31, 2023 12:39 am

We have never used both of the tabletops and poles simultaneously in our Duetto. I bought the Fiamma tripod foot and then cut one of the the AutoSleeper legs down to size. It then needed a couple of cuts into the end of the tube and a bit of hammering to make the end taper enough to fit the table socket

Fiamma Table tripod

Fiamma Table tripod

Re: Fiamma Table tripod

Re: Fiamma Table tripod

Re: Fiamma Table tripod

Re: Fiamma Table tripod

Re: Fiamma Table tripod

Re: Fiamma Table tripod