whale mixer tap small leak
+2
Peter Brown
babian
6 posters
The Auto-Sleeper Motorhome Owners Forum (ASOF) :: Auto-Sleeper Motorhome Forums :: Auto-Sleeper "Van Conversions" Forum
Page 1 of 1
whale mixer tap small leak
hi, Warwick XL 2014, anyone taken main sink whale mixer tap apart too cure small leak from below swivel spout, main body ?? any spare parts available or spares dealers? have emailed whale for advise , no reply yet.
has only just started leaking.
thanks for any help.
Ian
has only just started leaking.
thanks for any help.
Ian
babian- Member
-
Posts : 1094
Joined : 2019-05-11
Location : Northamptonshire
Auto-Sleeper Model : Warwick xl
Vehicle Year : 2014
Re: whale mixer tap small leak
[You must be registered and logged in to see this link.]
Unscrew lever, loosen hidden alan grub screw and pull off top. Unscrew domed cap and remove. Pull out cartridge. If its not the cartridge leaking you'll need to replace the tap.
Unscrew lever, loosen hidden alan grub screw and pull off top. Unscrew domed cap and remove. Pull out cartridge. If its not the cartridge leaking you'll need to replace the tap.
Peter Brown- Donator
-
Posts : 10635
Joined : 2012-11-10
Member Age : 72
Location : Staffs
Auto-Sleeper Model : Broadway EB
Vehicle Year : 2016
Re: whale mixer tap small leak
We had the same problem with our Whale mixer tap. It was the swivel joint that leaked, not the cartridge, and the tap was replaced under dealer warranty.
_________________
Previously symbol-bath
1996 - Autosleeper Symphony 2010 - Autosleeper Symbol 2018 - Autosleeper Kemerton 2023 - Autosleeper Kemerton XL (Fiat)
Kemerton-bath- Donator
-
Posts : 1174
Joined : 2013-01-06
Member Age : 65
Location : Bath
Auto-Sleeper Model : Kemerton XL (Fiat)
Vehicle Year : 2020
Re: whale mixer tap small leak
Kemerton-bath wrote:We had the same problem with our Whale mixer tap. It was the swivel joint that leaked, not the cartridge, and the tap was replaced under dealer warranty.
Same problem with mine, photo is of the tap that was replaced.
Peter Brown- Donator
-
Posts : 10635
Joined : 2012-11-10
Member Age : 72
Location : Staffs
Auto-Sleeper Model : Broadway EB
Vehicle Year : 2016
Re: whale mixer tap small leak
hi, thanks for the great info above and stripped down photo of the mixer tap.
Ian
Ian
babian- Member
-
Posts : 1094
Joined : 2019-05-11
Location : Northamptonshire
Auto-Sleeper Model : Warwick xl
Vehicle Year : 2014
Re: whale mixer tap small leak
hi, just an update.
whale customer service sent very quick reply email. ( Monday morning)
they will be sending out new seals and instruction manual on how to repair leak ourselves ?
fingers crossed and we might be sorted soon.
will update on what we get and how to do the job.
whale customer service sent very quick reply email. ( Monday morning)
they will be sending out new seals and instruction manual on how to repair leak ourselves ?
fingers crossed and we might be sorted soon.
will update on what we get and how to do the job.
babian- Member
-
Posts : 1094
Joined : 2019-05-11
Location : Northamptonshire
Auto-Sleeper Model : Warwick xl
Vehicle Year : 2014
Re: whale mixer tap small leak
Peter Brown refers to an Allen Key to undo the grub screw behind the lever. On mine it is a small tamperproof TORX head grub screw. I am interested that Whale have sent you replacement seals. I had asked for O rings when I had the same leak and was told they were not available. The seals are actually a semi hard plastic and seem to get coated with lime scale which causes the leak. Cleaning the seals with vinegar or citric acid stops the leak until scale builds up again.
PS Because the grub screw is so far recessed I had to buy a set of Torx Screwdrivers - about £11 from Amazon (Draper)
PS Because the grub screw is so far recessed I had to buy a set of Torx Screwdrivers - about £11 from Amazon (Draper)
_________________
Best wishes - Ron
inspiredron- Member
-
Posts : 3436
Joined : 2012-06-02
Member Age : 83
Location : Ellesmere, Shropshire
Auto-Sleeper Model : Lancashire
Vehicle Year : 2012
Re: whale mixer tap small leak
When I need to undo some Torx security screws on a washing machine I bought a set of extended Torx bits. £3.
[You must be registered and logged in to see this link.]
[You must be registered and logged in to see this link.]
_________________
Peter L
PLOUGHLIN- Donator
-
Posts : 4892
Joined : 2014-06-24
Member Age : 54
Location : NORTH HERTS
Auto-Sleeper Model : MB Gloucester
Vehicle Year : 2011
Re: whale mixer tap small leak
If I recall it is T10 tamperproof that you may need. You can also get Allen keys I think which could be better.
_________________
Best wishes - Ron
inspiredron- Member
-
Posts : 3436
Joined : 2012-06-02
Member Age : 83
Location : Ellesmere, Shropshire
Auto-Sleeper Model : Lancashire
Vehicle Year : 2012
Re: whale mixer tap small leak
leak fixed.
2.5mm Allen key for mine. stripped tap cleaned off all the water scale with citric wet wipes and soft brass wire brush,after removing all the seals, u shape and solid seals , top and bottom of swivel spout.
all threads and nuts were only hand tight, adjustable spanner, no great effort and did it with tap still in situ. mind you don't lose that little grub screw.
have attached photos of whales useful instructions. they sent me new u shaped seals and reused the old cleaned solid seals.
I believe if yours leaks, then just strip the tap , really clean off every part of water scale and re assemble the whole lot and the leak would be cured. this is only my opinion tho, but easy job.
Ian
[You must be registered and logged in to see this link.]
2.5mm Allen key for mine. stripped tap cleaned off all the water scale with citric wet wipes and soft brass wire brush,after removing all the seals, u shape and solid seals , top and bottom of swivel spout.
all threads and nuts were only hand tight, adjustable spanner, no great effort and did it with tap still in situ. mind you don't lose that little grub screw.
have attached photos of whales useful instructions. they sent me new u shaped seals and reused the old cleaned solid seals.
I believe if yours leaks, then just strip the tap , really clean off every part of water scale and re assemble the whole lot and the leak would be cured. this is only my opinion tho, but easy job.
Ian
[You must be registered and logged in to see this link.]
babian- Member
-
Posts : 1094
Joined : 2019-05-11
Location : Northamptonshire
Auto-Sleeper Model : Warwick xl
Vehicle Year : 2014
frederic, RogMcC and IslandSparky like this post
Re: whale mixer tap small leak
I have a comet tap that is leaking at the base but it looks similar to this I see what looks like a black rubber seal at the base. I am hopeful I can get at the seal without removing the tap as it seems to be built into the sink cupboard.
road warrior- Member
-
Posts : 57
Joined : 2022-07-11
Location : BURTON ON TRENT
Auto-Sleeper Model : WINCHCOMBE
Vehicle Year : 2016
Re: whale mixer tap small leak
Interesting that Whale sent you new seals. Some years ago they sent me a complete new tap. At the time I cleaned up the existing seals and all was well. This year it started to leak so badly that we had to switch the pump off when not in use. This time it was the cartridge which I was able to replace from the new tap. Replacing the complete tap is not as difficult a job as it first appears provided that you have a suitable length and size box spanner to remove and replace the nut which holds the crescent shaped clamp (not shown in any of the pictures) that clamps the tap body to the sink surround. But it's still an awkward job so easier to use the existing body if the condition of the seals allows. Replacing the cartridge was perfect solution for me - in fact I suspect that I should have done that when it first started to weep slightly.
_________________
Best wishes - Ron
inspiredron- Member
-
Posts : 3436
Joined : 2012-06-02
Member Age : 83
Location : Ellesmere, Shropshire
Auto-Sleeper Model : Lancashire
Vehicle Year : 2012
Re: whale mixer tap small leak
i followed the excellent instructions given by babian to take the tap apart but the main body that is supposed to unscrew by hand wont move, even with a pair of mole grips it wouldnt move - as i say mine says comet on the top but it looks identical - any thoughts ?
road warrior- Member
-
Posts : 57
Joined : 2022-07-11
Location : BURTON ON TRENT
Auto-Sleeper Model : WINCHCOMBE
Vehicle Year : 2016
Similar topics
» Mixer Tap Leak 1999 Symbol
» Tightening Mixer Tap
» Kitchen Tap leak Symbol 2002 (Gold Mixer Tap)
» Kitchen Mixer Tap
» Mixer tap in Duetto
» Tightening Mixer Tap
» Kitchen Tap leak Symbol 2002 (Gold Mixer Tap)
» Kitchen Mixer Tap
» Mixer tap in Duetto
The Auto-Sleeper Motorhome Owners Forum (ASOF) :: Auto-Sleeper Motorhome Forums :: Auto-Sleeper "Van Conversions" Forum
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum