Fuse holder missing

Hi all new to this toilet not flushing opened outside door pulled cassette out and noticed this see pic( looking upwards)

This link shows where fuse should be..

[You must be registered and logged in to see this link.]

To post your photos, go to home page, scroll down to 'factsheets' and you'll find instructions in that section.

Paulmold wrote:This link shows where fuse should be..

[You must be registered and logged in to see this link.]

To post your photos, go to home page, scroll down to 'factsheets' and you'll find instructions in that section.

Mines looking at it a glass one

I suppose technology has changed things over the years, best load up photos.

I assume the wires go underneath and connect to the cartridge fuse holder. If so it will be something like the unit at the link below:

[You must be registered and logged in to see this link.]

You could replace it with any type of fuse holder and 5A fuse.

Sharpee21 wrote:Hi all new to this toilet not flushing opened outside door pulled cassette out and noticed this see pic( looking upwards)

Should there be a fuse and cap thing is that why toilet not working it’s a 1988 autosleeper legend gl manual petrol can’t load pic? Thank you paul

Hi
Welcome to the forum from Bridington 
Boaby

Hi.

These comments might help.

We had a non-flushing toilet when we bought ours (1996 Talent). Thetford c2. I found what turned out to be the fuse in one of the drawers with a broken plastic holder/cap.

What had happened is that the external plastic casing of the fuse holder had broken around its circumference. Hence the fuse couldn't be held in place.

My solution was to fix a new lever/blade unit. They are about £40. It is secure by about four screws on the underside of the toilet casing. The fuse unit on the replacement was of a different design so I guess the original had a design fault that Thetford improved on.

You might have a different toilet/ problem, but your picture does look like what i saw with ours.

It should be possible to fit a new in line fuse and by pass the broken fues holder. First step would be to investigate by removing the lever unit.