VW Topaz 2006.

Hi, Does anyone have a VW Topaz T5. I have a 2006 Topaz and I have no rear  seat cushion any more. It has been misplaced. 
I am looking to get one made and I can hopefully get a plain blue to match.
I could do with finding out the exact size and aalso any straps that are attached that are there to keep it in place. 
Any help much appreciated.
Thanks Steve

Hi Steve
Welcome to the forum from Bridington 
Boaby

Hi Steve
I have a 2006 T5 Topaz, which cushion do you need the size of, I can measure mine for you.

Hi Enn,
I am missing the rear seat cushion behind drivers seat. I think it is cushion no 4 on manual. also the infiller cushion between the front seats.
I am going to get some made up with close matching fabric, probably a plain blue.
Could do with some pics and an idea of placement and lengths of fixing straps.
thanks a mill.
any help much appreciated.
STEVE

Hi Steve
Here are some pictures that may help, our piece that fits between the front seats is wrapped up buried in the attic somewhere, may be someone else might photograph theirs for you. We have never used the ‘extra’ pieces of bed making foam, preferring to rely on soft cushions or just leaving them out, they take up too much storage.
From what I remember, the piece that goes between the front seats has two fold out legs, and it stands on the floor like a small stool.
If you have no luck elsewhere I will have a rummage in the attic sometime and take some pictures and ,measurements.

Hi again.
thanks for the photos and neasures
just wanted to double check that they are for the backrest cushion. The measurement and diagram you gave has a angled notch out on bottom right corner 50x100mm. The backrest cushion picture shows no notch that I can see but there is a notch on the seat cushion.
just wanted to check if the measures are for the right cushion before I got it made.

Hi Steve

I took it to mean the seat cushion as this is how you described the one you needed, sorry. I will measure the back rest cushion for you when I'm home, it should be the same length and wide enough to fill the gap left when the seat is pulled out to form the bed.
I'll give you the measurements later.

Thanks. Yep I re read the message and i can see what you mean. Thanks a mill.

Back rest measurements:
Board - 370 x 1210 mm
Foam - 400 x 1220 mm
There is one strap on the right hand top corner 70mm long with a single popper that should have the other part to connect to on the side of the sink unit.

Hopefully this is useful and will enable you to get one made up.

Thanks perfect.