2005 Topaz.

Hi Everyone
I'm new to the forum so please bear with me!
My 2005 Topaz is missing a 'Cranked leg table' clamp. It is mounted on the sliding door 'B' pillar with two captive nuts and bolts. The two bolt holes (60mm centres) are in the vertical plane (bolts also missing) the tube 38mm diameter is also located on the floor in some type of 'cup' which is screwed with a single screw, to the floor.
I am wondering if anyone out there has for sale a redundant bracket and cup to fit a Topaz small table? Alternatively has anyone any idea which type of clamp was used and where they can be purchased? My dealer says A/S are no help.

Living in hope
Oldguard

AS are possibly the most helpful of any manufacturer.  Give the AS spares dept a call, quote the build number from label in glovebox and they will tell you if they have what you want. 

When you have a moment, a brief introduction would be welcome...

[You must be registered and logged in to see this link.]

PLOUGHLIN wrote:This is the normal cranked table leg fittings. [You must be registered and logged in to see this link.]

Thanks for the link:
My table leg is of two different tube sizes so the top will fit the larger diameter tube that is used for the main table. I wish to retain this option. It seems AS were informed of the build number but because of the age of the vehicle have no record of the type of bracket used, Strange!
Regards
Oldguard

Personally I would contact the A/S parts dept directly. The same fittings you refer to have been in use on a Topaz since it was first designed and were still I use on the last models in 2017. Usually the build number can help but as you van is over 10years old it won't be much use to the parts dept as they don't keep records back that far. Basically just ask for the fittings for a topaz small table, you may have to purchase the leg as well as it may come as part of the kit.