2002 concept kel alarm

Hi all.

I took 3 wires out of this alarm last year, took a photo so as to know how to replace them, and have now lost it!

Does anyone have one of these alarms, who would kindly send me an image, so as I can put them back in the correct place. Its not the thicker wires, just the small thin ones, if that makes sense I have a duetto, but unsure if these alarms were factory fitted?

I would be extremely grateful.

Kindest regards

Denise

Any help?

http://www.keenelectronics.co.uk/conceptinstallation.html

PLOUGHLIN wrote:Any help?

http://www.keenelectronics.co.uk/conceptinstallation.html

Hi Peter

Thank you for your reply. I really appreciate it. I have got those diagrams, but sadly, female with no electrical experience, couldn't make heads nor tail of them

The alarm is all in situ and its just really a photo that I need of the the wiring going into the terminals. Thought if someone had the same they could take a snap for me. God knows why the 3 wires were took out in the first place. I clearly didn't realise that all I needed to do was take the battery out!.........

The wiring diagram is colour coded. What colour are the 3 loose wires?

Hi peter.
Ok have taken a photo. Going to try and upload it! There on l/h/s...terminals 1 2 and 3. Wires that were out are red,blue and grey.
I noticed on the diagram the white wire is going into the 3rd terminal, but mines going into the 4th and I certainly dont recall taking the white one out? Anyway will try to upload this pic....thanks Peter

Its the 3 on the left of this pic that was out....

Right, from the pic none of the wires on the bottom seem to correspond with the wiring diagram. The three loose wires are in one cable so suspect they are from the PIR, terminals 1, 2 & 5 on the diagram. So try Grey/red/black in 1/2/3 respectively.

Hi Peter

Are you saying, take a black from one of the other terminals? The diagram shows 3 as being white? I wonder if it's worth me taking them all out and starting again....as per diagram?

I will go back to the drawing board again tomorrow

Thanks for your help with this Peter. Really do appreciate it!

Denise

The diagram doesn't show what colour wires go where from the other side of the connector. The coding is only for the small wire sizes, so don't remove the other wires, unless you can get confirmation from the manufacturer what goes where.

The three loose wires in one cable appear to correspond to the wires from the PIR unit, one is power in, one is power out, and one is signal from PIR.