Awning rain seal

When it rains water coming off the van roof runs between the gap on the roof and awning, when it rains hard it like a waterfall meaning everything gets wet when the sliding door is opened. I have seen Thule do a EPDM strip to stop this has your van got one fitted if not what did you do to stop this. Unfortunately to fit the EPDM now I would have to take the awning cassette off which I cant do on my own.

Anyone else have this happen what did you do, Do Autosleeper not fir the EDPM as standard

Hi, yes I had the same problem, there should be a foam strip to fill the gap, I bought a 4 meter strip off eBay ,it has a sticky side to it  to hold in place 20 x 30 mm.cost about £10 .hope this helps.

There is a rubber moulded seal that fits into a slot on the as ing body and seals the gap. I bought it for my Omnistor awning on a previous van which, while mounted on the wall of a coach built had a 5mm gap between wall and awning for water to penetrate. The seal worked!

I also bought a moulded strip that slides into a groove in the awning, the other edge fits tight to the van wall. They can be bought in various widths up to about 60mm. Ebay from what I remember.
Al.

Unfortunately my Omnistore 6300 hasn't got a groove at the back, looks like I am going to have to find some help or take it somewhere to fit the EDPM foam/rubber strip.

I assume removing and refitting the awning is a 2 man job as its heavy. Moulded strip a in a groove would have been so mush easier.